Sunday, June 28, 2015

Priming: Fenders & Chain Guard


Today I finished sanding the chain guard and primed it and the fenders. I strung a rope in the car-hole (garage is too elaborate for what we have) and hung the fenders by their braces, which I taped-off with masking tape (Photo #1). To hang the chain guard, I used a "modified" wire hanger (Photo #2). I primed both sides of everything (topside and underside) to protect against rust and wear. I'll paint and clearcoat both sides, too.

I put three light coats of primer on all three pieces, which seemed to give me good, smooth coverage. Supposedly, you can start applying paint within 15 minutes, but I'm going to wait at least 24 hours just so the primer has a chance to get really dry and hard. I'm also storing the parts in a very warm laundry room--still hanging up--to maximize drying.

By the way, I'm using Ace Rust Stop products for this paint job--so far, so good.

Oh, and if you're working in an enclosed space with poor ventilation, always wear a mask. Fortunately, our car-hole is so small that ventilation (if not a cross breeze) wasn't too much of a problem with the door open, but I was still glad for my mask, and took frequent breaks to step outside. Still might have done some brain damage-amage-amage.

No comments:

Post a Comment